Frequency Response: 20 Hz – 20 kHz (+/- 0.5 dB, 8O load, 3 dB below rated power)
Protection Circuits: Short circuit, DC, Undervoltage, Temperature, and Overload protection
RTI or 3rd Party Control: IP (RJ45), GPIO (Phoenix Connector)
Power Supply: UREC™ universal mains switch mode power supply with Power Factor Correction (PFC) and standby converter
AC Input Voltage: 100-240V~, 50/60Hz, 150W
Power Rating: 1% THD @ 120VAC and 230VAC
Standby Consumption: < 0.5W
Mounting: Rack mount or free-standing
Dimensions (W x D x H): 17.35” x 12.6” x 1.75”, 440 mm x 320 mm x 44.5 mm
Rack Units: 1U
Weight: 8.4 lb (2.8 kg)
Operating Temperature: +32°F to +104°F (0°C to +40°C)
Warranty: Three Years (Parts & Labor)
Prop 65 Declaration: This product contains Butadiene which is listed on California’s Safe Drinking Water & Toxic Enforcement Act of 1986. This Act, commonly known as Proposition 65 (Prop 65), establishes a list of chemicals which the state of California’s risk assessment process has determined to present a risk of cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
*All features and specifications are subject to change without notice.
Included in the box:
AMP-8-125, power cord, 6-pin Phoenix input connectors (2), 4-pin Phoenix output connectors (2), 8-pin Phoenix GPIO socket connector (1), adhesive rubber feet (4).
Features:
Eight analog audio source input channels (balanced or unbalanced) and one digital input (S/PDIF).
Four Lo-Z stereo or eight Lo-Z mono output zones, four Hi-Z mono output zones, or a mix of both.
Class D amplifier provides a robust and clear audio experience with 125 Watts @ 4Ω/8Ω per channel or 250W @ 70V/100V per channel.
Daisy-chain multiple amplifiers to expand the number of zones by distributing up to two audio inputs or zones.
Built-in DSP allows for fine-tuning acoustic characteristics for each zone.
Easy configuration via LAN or Wi-Fi.
IP and GPIO control options.
Free-standing installation or rack-mount (rack-mount kit included).
Overview:
The AMP-8-125 power amplifier delivers configurable and reliable high-performance audio power amplification for commercial and hospitality applications that demand a mix of low impedance and high impedance outputs. With a compact 1U design, this DSP-enabled Class-D amplifier can drive low impedance 4O to 16O loudspeakers as well as high impedance 70V/100V transformer-coupled loudspeakers. The AMP-8-125 can accept eight balanced or unbalanced analog inputs and one stereo S/PDIF digital input and delivers eight low impedance mono channels (or four low impedance stereo zones) at 125W per channel, or four 70V/100V mono channels at 250W per channel.
For set-up, the RTI web GUI enables effortless browser-based configuration of the installed system. Its DSP configuration options include multizone setup, input mixing, priority and ducking, restriction, input and output EQ, S/PDIF output routing, high-pass filter, speaker presets, delay, Wall-S1 controller configuration, sine wave generator, and more.
)
