Specs:

Lutron RR-15APS-SW | Plug-In Appliance Module


• 1/2 HP or 15 A General Purpose Plug-In Appliance Module (1 receptacle)
  
• Power: 120V ~ 50/60 Hz
  
• Typical Power Consumption: 0.3 W, Test conditions: load is off
  
• Regulatory Approvals: cUL, UL, FCC, IC, SCT, NOM (-3PD only; -15APS pending)
  
• Environment: Ambient operating temperature: 32 °F to 104 °F (0 °C to 40 °C), 0% to 90% humidity, non-condensing. Indoor use only.
  
• Communications: Plug-In Modules communicate with the system through Radio Frequency (RF) and must be located within 30 ft (9 m) of a repeater. System devices operate on frequencies between 431.0 MHz and 437.0 MHz.
  
• ESD Protection: Tested to withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2.
  
• Surge Protection: Tested to withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits.
  Power failure memory: should power be interrupted, the RF Plug-In Module will return to its previous state when power is restored.
  

Features:

• On a single-tap of the toggle button, load toggles ON or OFF.
  
• The appliance module may be used with, but is not limited to, the following: Task lighting – Monitors – Fans – Humidifiers – Printers
  
• The appliance module may NOT be suitable for use with devices that require any of the following:
  
• Shut-down process before power is interrupted, such as computers.
  
• Cool-down process before power is interrupted, such as projectors.
  
• Programming, such as clocks or DVRs.
  
• Long warm-up cycle.
  
• If an over-temperature condition is detected, the LED on the unit will ash a unique sequence (double-blink, then pause) and turn the load off. Proper installation and conformance to all specifications should be ensured before proceeding. To return the device to normal operation, cycle power to the device
  

Overview:

RadioRA 2 RF Plug-in Modules are simple to install and easy to use. RF Plug-in Modules allow floor and table lamps (RR-3PD-1) as well as general purpose switching loads (RR-15APS-1) to be added to a system quickly and easily using Clear Connect RF Technology. They can be hidden behind furniture or appliances.

Review: